I make them using my Nestability dies from Spellbinders. I use my Cuttlebug to do all my die cutting and it works perfectly. To start, I cut the cardstock 8 1/2"x 4 1/2" and score in the middle:
Next, fold the cardstock and place your largest die with the top of the die just over the top of the fold. This is very important, as this will be the top fold of your card.Here is the picture from the angle that you cut. You need to remember that the "pointy" part of the die faces UP to your B Plate. You can see from the past impression on my C Plate, I have done this WRONG before. Man oh man I had trouble getting the die OFF the plate!Run it thru your machine and if you use thick cardstock, like PTI, run it back and forth just to make sure it cuts both layers. When you are done, it will look like this:Next, you can work on the inner layers of your card. For my card, I wanted the first layer to be white with a strip of embossed Kraft thru the middle. I layered them both at the same time, but you could just as easily do the white piece first and fiddle around to decide what you need next.
One tip I have is to tape the die down to the cardstock to prevent any moving. This is especially important when die cutting around an image already stamped. I use a small piece of tape, be sure to place the sticky tape to the OUTSIDE of your die-not touching the inside. That way it won't accidentally tear your cardstock. Here is a close up of my tape, you can tell that I use this tape over and over. I keep it taped to my area for quick access. Hey, it doesn't have to be pretty to work!Here is the finished card (it was my challenge card from a few weeks back). Well, I hope this was useful to you. If you have any questions, you can leave me a comment and I will respond with an edit to this post-for all to read.
Thanks for stopping by and have a great day!